OBD2 Car Diagnostic Tool Share

Optional solutions to solve  Ktag v6.070  error Kessv2 “this tool is not updated”… Wish this helps. Here is the error message when running ktag. kess v2 ACHTUNG: Tool ist nicht aktualisiert. PC mit Internet verbinden und Software erneut ausfuhren ( kess v2 CAUTION: Tool is not updated. Connect PC to the Internet and run software again)    Change another laptop / use another USB cable for reflash by J-Link, disconnect internet connection, re-install ksuite software and driver. Run again the Ksuite software. If ksuite v1.8x doesn’t work, try ksuite v1.93. Most people managed to solve this issues with the help of ktag ksuite 1.93. Ksuite v1.93 download: https://mega.nz/#!5p0mRYyT!4OV-XDyQtTCLuB2UQDhgIE26qB28TObS18MFrUo0VmM (this K suite v1.93 has been solved  KESS V2 Firmware V4.036  with the same issues. For ktag users, try it on your own risks. Good luck.) If all solutions above do not work, you had bette...

Invested on Chinese ECU programmers , FGtech Galletto 4, CMD flasher v1251, clone Alientech (Ktag and Kess v2), MagPro x17... I read a lot, with each opinion. Over all that I read is old (<2011). So here's what I remember: - FGTech Galletto 4 : it is the best product, many times cheaper than the competition, at 40 euro you have a good Chinese clone for all cars, trucks, motorcycles, Marine, BDM MPCxx, BDM Boot Mode, checksum etc ... Good support - CMD flasher v1251 : The Must, one diagnostic interface, for reading and writing flash memory on the CAN line (not K-line) of computers with motor MED9.1, MED9.5, EDC16U3x/CP, EDC16CP31, EDC16CP36, EDC16C3 and EDC16C9 fuel injection. you need this tool only for new vag ecus, cause they are obd, even tprot - Magpro2-x17: This is very good for the latest ecu cars only and for Denso also you have good support. All X17 owner will get new hardware soon, all in one tool, BDM, OBD, boot + + - Alientech: Great tool, support is cor...