Posts

Showing posts from May, 2014

How to Fix the Idle Control Valve in a Cadillac

Unplug the electrical obd2 scanner connector on the valve by lifting the locking tab while pulling the connector out of the valve. Remove the 8mm bolts that attach the valve to the throttle body. Pull the valve off the side of the throttle body. Bolt the new valve and new gasket onto the side of the throttle body. Tighten the bolts securely. Plug the electrical connector into the valve. Start the engine and turn it off. Unplug the electrical connector from the valve. Start the engine and adjust the idle speed screw on the throttle body, using a screwdriver, until the engine idles at 675 rpm. Start the engine digiprog 3 and adjust the idle speed screw until the engine idles at 650 rpms. This sets the base idle speed to a place where the valve can have full control. Turn off the engine. Plug the electrical connector back into the idle control valve. Start the engine. Verify the control of the idle speed by turning on the air conditioning and observing the change in idle speed when t...

How digiprog3 ST04 and ST01 to work

Image
The day before yesterday, a friend asked me what digiprog 3 ST01 and ST04 cables to do? According to my friend saying, he bought this mileage programmer from the obd365 in Feb., everything was all right there. Earlier this week when he adjusted the travel distance for Toyota and the 2004 Honda 2008, it showed that was required for the two cables to achieve mileage correction to the main unit.   Apart from my friend's request, I also heard of several customers online that this happens. According to the introduction of digiprog iii, it allows users to adjust the data of some cars’ odometers from the OBD2 port, but to some cars, it is required to decompose and access mileage via dashboard. And then cables for connecting the correction tool odometer will be the ST04 and ST01 cables and chip is required. If you enter a car in the programmer odometer, the device will tell which cable it needs. By using the cable connected to Digiprog, you will be able to correct driving data and fault...